Matrix user forums

This is my first post in this great forum.. My apologies if it is not in the right section(as i am unable to post in Flowcode4 section of the forum)... I have read the forum posts that are very helpful understanding the Flowcode functionalities... The Flowcode is the best programmable resource so far i have seen.. Very easy, user-friendly and thanks to the forum members and admin for their great valuable support...
I have been using Arduino based on ATMEGA328P chip in the past and want to shift to PIC based micro-controller... Frankly speaking, i have very little idea about the PIC microcontroller and programming....I have purchased The Arduino using "Processing" language similar like C++...
As i have good awareness of almost all the functions of Arduino in the following link:
http://arduino.cc/en/Reference/Libraries

My Question is can i use the Arduino libraries in Flowcode for PIC?.. can i convert the Arduino functions into Flowcode Macro? Any example?

PS:
I recently purchased QL 2006 PIC Programmer, few 18F452 and 18F4550 chips...

Flowcode V4 questions should be posted onto the dedicated V4 forum. You should try the instructions here:
http://www.matrixmultimedia.com/support ... f=29&t=602

If you are still struggling to access to forums, please PM me with a screenshot of your Flowcode licence label (inside the CD) and I'll sort out access for you.

Hi Steve,
As i do not have Flowcode so can't post in that section. can you please tell me where a potential customer can ask questions in your forum before purchasing the Flowcode.
Regards

moving due to subject matter not relevant to articles

There is a post in the article section of the website which explains how Flowcode can be used with Arduino hardware. I am not familiar with the libraries available for this device, but I suspect that they will be written for the Arduino software and as such will not be transferable to the GCC compiler toolchain that is used by Flowcode.