Matrix user forums

I keep getting this next error, can someone help me out with the next error:


Launching the linker/assembler...
c:\program files (x86)\matrix multimedia\flowcode v4\boostc\boostlink_pic.exe -ld "C:\Program Files (x86)\Matrix Multimedia\Flowcode V4\BoostC\lib" libc.pic18.lib flowcode.pic18.lib rand.pic18.lib float.pic18.lib "adc_leds.obj" -t PIC18F4455 -d "C:\course\projecten" -p "adc_leds"
BoostLink Optimizing Linker Version 7.03
http://www.sourceboost.com
Copyright(C) 2004-2011 Pavel Baranov
Copyright(C) 2004-2011 David Hobday


Error: .obj or .lib file Incompatible version! (file uses V111, linker requires V113 to V113)
Error: Failed to process:libc.pic18.lib
Error: .obj or .lib file Incompatible version! (file uses V109, linker requires V113 to V113)
Error: Failed to process:flowcode.pic18.lib
Error: .obj or .lib file Incompatible version! (file uses V111, linker requires V113 to V113)
Error: Failed to process:rand.pic18.lib
Error: .obj or .lib file Incompatible version! (file uses V111, linker requires V113 to V113)
Error: Failed to process:float.pic18.lib


failure

Return code = -2

Assembleren mislukt vanwege de foutmelding:


FINISHED

It seems that during the update to V4.5 the .lib files have not been updated correctly. A reinstall of Flowcode will probably solve the problem (remember that you do not need to re-enter your licence code when reinstalling).

Alternatively, you could unzip the attached files into the "Flowcode V4\BoostC\Lib" folder on your PC.

hi Steve
I have done this two times, the first time i have re-install flowcode v4, and i had to try the compilation,
then i had 2 errors, the i did the last update then i had the same errors as before re-install.
now i have to try some manual changes till i get another error, then i have another re-install and now i can compilation again.
but i have now no new update shoud i thry that.
Frits

Steve i will thank you for the answer