Page 1 of 1
Using Serial LCD and Flowcode?
Posted: Wed Nov 09, 2011 5:07 am
by Werner
Hi Guys,
I am wondering if anyone has some direction for me in reference to using a serial LCD 16x2 with Pic 16F877A chip. Maybe an article or other post? I did some searching but didn’t come up with what I am looking for. Thanks for the help!!
Werner
Re: Using Serial LCD and Flowcode?
Posted: Wed Nov 09, 2011 11:01 am
by Benj
Hello Werner,
Is this any good for you.
http://www.matrixmultimedia.com/mmforum ... +of#p26890
Or are you using a LCD module with serial interface? If so then you should be able to use the RS232 component to control the display.
Re: Using Serial LCD and Flowcode?
Posted: Wed Nov 09, 2011 7:45 pm
by Dan81
Re: Using Serial LCD and Flowcode?
Posted: Sun Nov 13, 2011 6:39 am
by Werner
Thanks Guys for the info links! I did find both of these and read through them a few times but am not getting it? It looks like I can still use the LCD component macro but need to add a C Code box with that huge about of C code you have in the PIC_LCD.c file?? Am I anywhere close? Thanks again Guys!
Werner
Re: Using Serial LCD and Flowcode?
Posted: Mon Nov 14, 2011 12:29 pm
by Benj
Hello Werner,
PIC_LCD.c is a replacement for the LCD component C code. For my example you would backup the C file in your "Flowcode v4/Components" directory and then replace the file with the file from the forums. The LCD component then works as usual but using the new modified code.
Re: Using Serial LCD and Flowcode?
Posted: Wed Nov 16, 2011 12:49 am
by Werner
Hi Ben, OK I am following you now! Thanks I will give it a go.
Have a great day!
Werner