Flowcode Support Board

Posted: **Fri Jun 04, 2021 10:00 am**

Hi All.

PWM on PIC16F1938 has some issue if I adjust the duty cycle on Channel 1 then the duty cycle on Channel 2 changes
the pins in the properties correspond correctly Channel 1 RC2 and Channel 2 is RC1 .

: P2.jpg (21.56 KiB) Viewed 2759 times

: P1.jpg (56.67 KiB) Viewed 2759 times

Posted: **Mon Jun 07, 2021 11:28 am**

Hello,

Please can you post the program and I'll investigate this for you.

Posted: **Mon Jun 07, 2021 12:13 pm**

HI Ben

Here is the FC chart in my opinion CCP1 is Channel 1 and CCP2 is Channel 2 setting Channel 2 Channel one DC changes even on Hardware

Chip pins is CCP1 = RC2 and CCP2 = RC1

Modbus_Slave.rar: (3.32 KiB) Downloaded 268 times

Thanks for helping out

Posted: **Fri Jun 11, 2021 8:51 am**

Hi Team.

My sincere aplogiese! ,I am the bug

I found my mistake

Have nice weekend

Flowcode Support Board

Wrong PWM adjust

Wrong PWM adjust

Re: Wrong PWM adjust

Re: Wrong PWM adjust

Re: Wrong PWM adjust