Matrix user forums

Hello!

I've been working with a heart rate monitor (hand grip version) for a while and I've managed to make some flowcharts (attached) but they don't work. The flowchart which I use in node 3 is not entirely made by me and I have been told that it's not suitable for the final result that I want ...

Thanks for your reply Steve.

That sounds quite difficult thing to do for me, but I'll try anyway.

If someone have some flowchart that would get the heart rate monitor functional, then please, share it with me

Matt

Can someone please help me with this thing? I think the introduction of the heart rate monitor is piece of cake for most of you.

I hope someone would go into this and perhaps give me some flowchart.

Thanks

Matt

Hi all

It's me asking your help again. This time I'm working with a heart rate monitor (hand grip version), but unfortunately I haven't got it work yet. Can someone give me some hints or flowchart to get that monitor working?

Any help is welcome, because I have no idea how to proceed with this one ...

Thanks Martin. The flowchart (ThermoCalcDisplay1.fcf_avr) compiled successfully. So far so good :)

Now I'll try to combine it with those two other flowcharts (node 1 and 3). However I still would be grateful if someone, more skillful then me, could make me a working system that I described in case ...

Hello,

I hope this is the right place for my post this time.

My problem concerns about values that must be converted into another form. I'm working with E-blocks products (with Flowcode V4 AVR) and the idea is to send a temperature data from node 3 to node 1 via ZigBee connection. Node 1 is the ...

Ok. Thank you Steve, I'll post it to V4 forum. And I apologize to sending my message to wrong forum area.

Thanks Nicolas for replying to me. I managed to open that file ThermoCalcDisplay1.fcf (PIC version) with my AVR Flowcode by importing it like Benj guided. The file include that look up table. I tried to use that flowcode but when I tried to compile it to the microcontroller multiprogrammer I just ...

Hello,

My problem concerns about values that must be converted into another form. I'm working with E-blocks products and the idea is to send a temperature data from node 3 to node 1 via ZigBee connection. Node 1 is the coordinator which consists of AVR microcontroller multiprogrammer, graphical ...