Matrix user forums

BIG Thanks to All contributers, especially Kersing!

For anyone wanting to know I had to do the following:

configure the xbee's using XCTU modem configuration part with the above (see earlier post) details.

I then had to output this as RS232 strings with delays of 3 seconds between each (this was ...

Yeah i was using the Zigbee only because the RS232 macro wasnt working.

I now see this was a dead end

How do i initialise the xbee using at commands?

Thanks for the replies they are helpful!

Just for anyone interested the xbee modules I am using are:

http://proto-pic.co.uk/xbee-1mw-wire-antenna/

This xbee is connected to the controller via

http://proto-pic.co.uk/xbee-explorer-regulated/

The other XBee is the exact same model and is connected via USB Dongle

The Xbee's work when ...

Hi Benj, I have tried to suggested pin variation with no success.

I am getting a serial data packet sent from my ecio to the Data Out pin of my XBEE, however this data does not reach the other XBEE which is connected to my computer.

I have tried the RS232 module as well and it didn't work ...

Guys I have been struggling massively for the past 3 weeks trying to get two xbee's to talk to each other.

At the minute I have an ECIO28p that is connected in the following manner to a sparkfun explorer regulated xbee breakout board:

RX - Data In
TX - Data Out
VCC& GND accordingly wired.

My ...

Hi guys, I am very new to the ECIO and flowcode.

I am currently doing a project building an automated dragster and I am using a ECIO 28P (pic18f2455) to control it. I have a brushless motor connected via a BEC lead and an XBEE connected to C7 and C6.

What I need is the ability to send a message ...