Matrix user forums

Hi,

I bought both the flowkit and the EB006-00-8 both together as it was told to me that i needed the FLOWKIT if i wanted to debug by single stepping etc..

I assume i have version 8????? as per serial number????


Using only the EB006 to program,, the PIC18f242 appears to program up ok but will ...

Hi


changed to pic18F242 as this is a supported chip..

Using the flowkit in PROG mode, I try to program the PIC18F242, and it gives me an error saying cant detect USB..

When i put the flowkit into ICD mode it says cannot communicate with the ICD.

I do understand that the flowkit is not a ...

I have tried the following.

Programming a 18F242 on an EB006 will program but no debug, message saying cannot communicate with ICD.

also
Programming a 18F242 via flowkit produces a USB error and of course wont program or debug.
PIC is healthy as i can program using PICKITS.

any advice greatful ...

thank you for the advice, but not sure why the capital letters is a issue,,,



I have tried the following.

Programming a 18F242 on an EB006 will program but no debug, message saying cannot communicate with ICD.

also
Programming a 18F242 via flowkit produces a USB error and of course wont program ...

Hi All

I have done a 1HZ flasher to prove that things work OK.

compiled and it works on FLOWCODE,

It WONT PROGRAM ON A EB006 board but it will program when I import into MPLAB and program it via ICSP using PICKIT3.
THE PROGRAMS WORKS OK AND THE LED FLASHES OK

I THEN UNPLUG THE PICKIT3 AND PLUG ...

From Steve.

I did post something on a different section basically about the same thing.

using version 5 of flowcode, an EB006-00-8 , Flowkit, windows 7
using a PIC16F88 with the code as attached. Nothing connected to any PIC pins.

the code comprises of
ON bit 0 portA
delay for 1 sec
Off bit 0 ...

Hi MArtin,

Ive signed up with the V5 forum now.

back to the ICD problem.

I have had the flowcode working and compiled and it has worked on the board, but I 98 percent of the time get an ICD error cannot communicate with the device.
I suspect the config bits are correct as I have checked many ...

Thanks for swift reply,

Flowcode file attached

I have changed the PIC to A PIC18F25K22

Regards
Steve

Just bought the V5 professional, EB006 with the flowkit also.
I managed to get the ICD going once with the PIC16F88 as supplied but nothing else.
I created a program to pulse an led with a delay then off again, The 1HZ program. which did work once.

Every time I try to use the ICD I get "The ...