ECIO 4OP

[franky]

Hi to all!
I have a problem when I try to send a program..

I've done a program whit flowwcode software but when I try to send to ecio 40p the software tell me "send failed"

how can I do?
thanks a lot!

[Steve]

Hello,

Please give us more details about the problem (exact error message, etc) and we'll try to help.

[franky]

i! so..
when I try to use ECIO program I can read the micro, I can erase it and I can reset it, but when I try to send a program I can read the hex file and the software show me that it has charged it, but after that when I select "send file" the software start to send the hex file but then show me "send failed"

I've already try to reinstall the ECIO drivers but nothing change, I tried also to change the micro but I have the same problem.

thanks to all!

[Benj]

Hello

What version of Flowcode are you using? It could be that your using the old programming tool. The latest version of the tool can be found here.

http://www.matrixmultimedia.com/software/ECIOprog.zip

Also you may want to switch off the power saving feature of Windows as this is known to cause problems.

http://www.matrixmultimedia.com/support ... .php?t=537

Let us know how you get on.

[franky]

Hello!

I'm using Flowcode V3 and I fink that the drivers are the same that you have attached.
thanks a lot!

[Benj]

Hello

Did you try the new programnming tool and disabling the power management?

Did they work?

I did not attach drivers!!!

Think is spelt TH

[franky]

hello Benj!

I tried whit another pc and it works correctly!...

thank you very much!