16F628A EEPROM compile error.

Post by **medelec35** » Sun Sep 25, 2011 2:49 pm

When using EEPROM component, flowchart does not successfully compile.
So I changed Define3=#define MX_EE_TYPE3
to
Define3=#define MX_EE_TYPE1
within attached 16F628A.fcd
Now flowchart compiles OK.

Unable to test with real hardware as I was PM'd by someone who could not compile flowchart, so I have not got correct chip to test with.
However It works in the simulator I use for testing.

Would someone who has 16F628A mind testing solution and confirm if works on real hardware please.

The test flowchart:
If EEPROM is reading and writing OK, then LEDS connected to RA0 and RA1 will both change state after 2 seconds.
LED connected to RA2 is just flashing at 1Hz to test configuration settings and OSC speed are correct.
Thanks

Martin

Post by **medelec35** » Mon Sep 26, 2011 8:54 am

It has just been confirmed, using the attached fcd file will allow EEPROM to work on 16F628A hardware without any issues.

Martin

Post by **Benj** » Mon Sep 26, 2011 9:56 am

Cheers Martin,

I will add this information to my working set of FCD files.

Post by **medelec35** » Mon Sep 26, 2011 1:23 pm

No problem Ben.
So long as it helps.

Martin

mauro · Post by **mauro** » Tue Sep 27, 2011 8:09 pm

Thank you Martin,

Checked on hardware... all ok..

Post by **medelec35** » Tue Sep 27, 2011 8:15 pm

mauro wrote:Thank you Martin,

Checked on hardware... all ok..

Your welcome mauro.
Thanks for confirming fix works on hardware.

Martin

Matrix user forums

16F628A EEPROM compile error.

16F628A EEPROM compile error.

Re: 16F628A EEPROM compile error.

Re: 16F628A EEPROM compile error.

Re: 16F628A EEPROM compile error.

Re: 16F628A EEPROM compile error.

Re: 16F628A EEPROM compile error.