Unable to compile

[Rotac]

Hello,

"Suddenly" I can not compile to C, to hex, to chip.
I get the anouncement :Unable to create C file Y:\......

Who has a solution to solve this problem?

Regards

Rob

[Spanish_dude]

Did you open your Flowcode file from a usb stick or other external memory device ?

From your post : "Unable to create C file Y:\......".
When you create a file on your computer it's usually created on the C drive.

- Nicolas

[Rotac]

Hi,

yes, it is an external device, here a Nas drive. I have store the file on the local drive and compile the File and it works! very strange because it has worked with the Nas drive, but any way thanks for the Tip

Regards

Rob

[acestu]

Hi Rotac,

If you are using Flowcode 6 Beta then this problem was fixed in one of the patches, download and install the latest patch from the forum, this is the link for it:

http://www.matrixmultimedia.com/mmforum ... 53&t=12782

cheers
Acestu

[Rotac]

Hello,

I did, but after installation you have to registry again and I though never mind, I keep it by version 5

Ithink the problem is causes if you use to many subdirectorys?

Regards

Rob

[acestu]

Hi Rotac,

Try copying the file that you want to use from your external drive to your computers drive root ie C/: ?????????? then try it again because by doing this you are eliminating any sub directories...

cheers
Acestu