When compiling the warning about unconnected pins does not allow to abort. This is not a problem for small programs, but for large ones code generation can take a considerable time (when using large LUTs).
Please add the option to abort compilation when the warning is displayed.
Add abort option to "Pins not connected" warning
Moderator: Benj
Forum rules
Only feature requests will be considered here. General questions should not be posted in this forum.
Only feature requests will be considered here. General questions should not be posted in this forum.
-
kersing
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
Add abort option to "Pins not connected" warning
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis
-
Mantas
- Posts: 221
- Joined: Tue May 15, 2012 10:32 pm
- Location: Klaipeda, Lithuania - North sea, UK
- Has thanked: 57 times
- Been thanked: 27 times
Re: Add abort option to "Pins not connected" warning
Or option to disable pins unconnected warning, like for CAN component when you are not using DAC and NV pins.
Science is my true religion.
-
kersing
- Valued Contributor
- Posts: 2045
- Joined: Wed Aug 27, 2008 10:31 pm
- Location: Netherlands
- Has thanked: 553 times
- Been thanked: 1081 times
Re: Add abort option to "Pins not connected" warning
Mantas/Martin,
See this message for a solution to turn the warning off.
For this feature I want it enabled, but if I make the mistake to have unconnected pins I want to be able to abort compilation. One of my flowcharts takes 3 minutes to translate to C code and I don not enjoy waiting for it when I know it needs to be redone after connecting the pins.
Regards,
Jac
See this message for a solution to turn the warning off.
For this feature I want it enabled, but if I make the mistake to have unconnected pins I want to be able to abort compilation. One of my flowcharts takes 3 minutes to translate to C code and I don not enjoy waiting for it when I know it needs to be redone after connecting the pins.
Regards,
Jac
“Integrity is doing the right thing, even when no one is watching.”
― C.S. Lewis
― C.S. Lewis
-
medelec35
- Matrix Staff
- Posts: 9521
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
Re: Add abort option to "Pins not connected" warning
Oh I understand.kersing wrote:One of my flowcharts takes 3 minutes to translate to C
When I read the post and thought huh? For hex code generation there is a cancel button.
But you mean with C, as with C there is not.
So yes, I do agree with you Jac.
There should be an option to cancel.
Never noticed before as I don't compile to C that often.
I will remove my post and add a new request feature.
Martin
Martin