V6 Demo Component Connections

[Bobw]

Downloaded V6 demo to play withlast night.
Selected a 16F1827 chip.
When I place a toggle switch on either the System or Dashboard panel they show up just fine.
When I go to the properties for each switch, it will not allow me to set the connections to the PIC pins. I get the drop down boxes, for the first switch I selected port A pin 1. Soon as I click on the pin (bit) for the switch the drop down closes and shows the switch as UNCONNECTED.
I placed a Rotary (pot) on the panel and it worked just fine, shows connected to RN0 just like it should be.
Is this a bug, or did I miss a step?

Bob

[medelec35]

Hi Rob, Toggle switches are working fine for me.
I can select different pins and selection is retained.
Are you running the latest version of V6 (6.0.2.0 (27.09.2013))
If not take a look at this:
http://www.matrixmultimedia.com/mmforum ... 54&t=12949

Martin

[Bobw]

Yup, that is the version I am using.
Uninstalled/Re installed working properly now.
Go figure!
Thanks for the reply.

Bob