Hello,
I use Flowcode 4 with a pickit3 and the demoboard (18F45K20).
Programming the target from flowcode 4 it's ok.
But what i need to do for running the downloaded program ?
My code is in attachment.
thanks for your help
how running target with Flowcode 4 and pickit3
how running target with Flowcode 4 and pickit3
- Attachments
-
- Clignotement diodes.fcf
- this program blink all the led
- (4 KiB) Downloaded 204 times
-
Benj
- Matrix Staff
- Posts: 15312
- Joined: Mon Oct 16, 2006 10:48 am
- Location: Matrix TS Ltd
- Has thanked: 4803 times
- Been thanked: 4314 times
- Contact:
Re: how running target with Flowcode 4 and pickit3
Hello,
Looking at your program the only thing I have spotted is that the extended CPU setting should be set to disabled.
What are your PICkit 3 settings? Is it the PICkit that's stopping the device from running? E.g. if you power the board and remove the PICKit then does it run correctly?
Looking at your program the only thing I have spotted is that the extended CPU setting should be set to disabled.
What are your PICkit 3 settings? Is it the PICkit that's stopping the device from running? E.g. if you power the board and remove the PICKit then does it run correctly?
Regards Ben Rowland - MatrixTSL
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Flowcode Product Page - Flowcode Help Wiki - Flowcode Examples - Flowcode Blog - Flowcode Course - My YouTube Channel
Re: how running target with Flowcode 4 and pickit3
hello
you say : What are your PICkit 3 settings?
But Where can I see the pickit3 settings in Flowcode ?
you say : What are your PICkit 3 settings?
But Where can I see the pickit3 settings in Flowcode ?