hello, I'm trying to config serial interface with flowcode 6, but i can't find were you can chose baudrate. I guess that is standard 9600.
somebody link with labview 2013?
thanks.
about ecio40 serial interface
Moderator: Benj
-
medelec35
- Matrix Staff
- Posts: 9521
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
Re: about ecio40 serial interface
Hi ALOPEZ,
With Flowcode V6, after adding the RS232 component, all you do is right click on the component on your 3D System or 2D DashPanel and select properties.
Like with the majority of other components will allow you to choose different settings.
E,g in this component software and hardware mode, baud rate etc.
Sorry not sure about Labview.
With Flowcode V6, after adding the RS232 component, all you do is right click on the component on your 3D System or 2D DashPanel and select properties.
Like with the majority of other components will allow you to choose different settings.
E,g in this component software and hardware mode, baud rate etc.
Sorry not sure about Labview.
Martin
Re: about ecio40 serial interface
Hello,
I dind't explain right,i mean with usb serial mode,how you select the baude rate?
I dind't explain right,i mean with usb serial mode,how you select the baude rate?
- Attachments
-
- usbserial.png
- (158.31 KiB) Downloaded 294 times
-
medelec35
- Matrix Staff
- Posts: 9521
- Joined: Sat May 05, 2007 2:27 pm
- Location: Northamptonshire, UK
- Has thanked: 2585 times
- Been thanked: 3815 times
Re: about ecio40 serial interface
Ah Sorry,
I thought you meant RS232, and when you stated 9600 I put 2 + 2 together and made 5.
Martin
I thought you meant RS232, and when you stated 9600 I put 2 + 2 together and made 5.
Martin
Martin