Flowcode V6.0.7 and ICD3

[stephan]

Hello,

I used to program Microchip pic24FJ128GA010 with Explorer 16 via Flowcode . The only thing to do in to configure correctly the programmer and parameters for ICD3. (i.e : ICD3CMD.exe with -P%p - E -F%f.hex -M -Y -L)
But with the new realease of Flowcode V6.0.7 the ICD3 programmer doesn't find the hex file and return error code = 1.

I Wanted to know if someting has change with parameters configuration when I need to use ICD3.

Best regards.

Stephan

[stephan]

Hello,

Here is the answer !

Benj already answer for this problem : Parameters (16-bit PIC): -P$(chip) -F$(target).hex -E -M -L

It 's the same configuration as Pickit3

http://www.matrixmultimedia.com/mmforum ... ing#p50830

Next time I will look for the answer deeply !

Bye