EB006v9 and Flowcode 6

[Burtonian]

Hi everyone, some time ago I purchased Flowcode 4 professional an EB006v7 and several other eblocks.
Sadly after much frustration I decided enough was enough and put all the kit away in a draw. Recently I decided that I would have another go with Flowcode and was surprised to find that it was now Flowcode V6. For some reason my old Flowcode V4 would not load so I am thinking of paying for an upgrade to Flowcode V6 and buying a new EB006v9 programmer but I see that now I must use the mloader software. I have googled etc and I am unable to find any screen shots of this mloader software and before I spend another lot of cash I wondered if you guys could give me your opinion on the combination of the EB006v9 programmer with Flowcode 6 and I would like to use this to program a PIC18F452 chip. I am only using the 18F452 because I have access to several of them.

I look forward to your replies

Burtonian

[Benj]

Hello,

If you would like to resurrect your Flowcode v4 license then PM me with your username or email and I'll dig out the details for you.

Flowcode v6 uses mLoader but this should also work with your existing hardware so you should be able to install the free version and get 30 days of usage to test it out for your needs.

The v9 EB006 board includes the new Ghost functionality which consists of Programming, in circuit debug and in circuit test so it is a useful thing to have.