Access denied to a FCF file ????

[ksor]

I have made some changes to the example file coming with version 4:

4. Four digit counter using timer interrupt.FCF

The changes is:

I've added 4 X Led7Seg() and wired them up as common cathode and connected them.

Then I saved the filed and tested the function - works fine "on screen" in Flowcode.

I then configured to 16F628A and no WatchDog and compiled to ASM.

Loaded the ASM-file into MPLAB and simulated a run - BUT teh simulation just quit because the program counter was outside valid address.

That's the problem 1) - why ?

Problem 2) is that now I can't open my FCF file - Access denied - why ?

(Another test program of mine can't see no locks on the FCF-file)

The FCF-file is attached

[Steve]

This file seems to have some data missing from it. Is this another file you have been using with the demo version whilst trying to circumvent the demo version restrictions?

[ksor]

No - I un-installed the demo version - deleted ALL in regestry - rebooted and installed the new version.

And started to change the project.

[Steve]

I've tried to find the problem with this file without success, so I'm afraid you'll need to start again.

Your case does seem to be unique - no-one has reported any similar problems before. If you can provide a specific set of steps for us to replicate this problem here, we will try it out. But if we cannot replicate the problem, then I doubt we will be able to solve it for you.

[ksor]

OK - I'll try to convert the original fcf-file again.

[Benj]

This Post has been resolved here.

http://www.matrixmultimedia.com/mmforum ... 693#p17693