Configure chip screen incomplete

[mimiyum]

Hello,
Whenever I program my PIC using either HP-488 or EB-006 programmer board on Flowcode V5.4, I just use the USB connector.
This means I have to enable "Low Voltage Program on the configure chip screen. When I click on Build>Project Options and click on "Configure chip" the screen looks incomplete and i can't find the buttons for cancel or options or whatever.

The screen I get is this

configure chip.PNG

(68.78 KiB) Downloaded 1857 times

any amount of stretching the window will not work.

Please help...
Thanks

[Enamul]

Hello
I guess I have seen this issue before and David suggest to change screen resolution. The problem get sorted..You can try or you might have to wait till Monday.

[mimiyum]

Hello,

Ok, I know now...it's not the screen resolution but the text size. My display text size was originally set to 125%. When I set it to normal the configure chip screen now looks normal.

I understand now that Flowcode may have been meant for younger people who have very good eyesight and don't mind small text on their screen

Thanks for the tip Enamul!

[Enamul]

You are welcome. Thanks for letting us know.