scale issue

[Steve001]

Hi Not sure if this is me or not

on 2d dash placed

generic lcd display then set to 4 x 16

switch array on port B

Analogue slider

The scale seams to be off or can you alter the zoom on each component ?

Under normal viewing the display shows lines 0,3 very small and lines 1,2 quite large and the test is quite burley.

Also in the lcd properties box there is a menu for lcd display R/W pin if hard wired to ground set to "false" if hard wired to ground the menu options shows"yes" , "no"


if I zoom so I can see the 4 lines on my display the analogue input slider is off the top of the screen
Screen res is set to 1680 x 1050


Steve

[LeighM]

Hi Steve,
I guess we will need to look at default sizes.
To alter size and position I personally use the position and size properties for the component ...

world_size.jpg (46.22 KiB) Viewed 3272 times

Hope that helps

[Steve001]

cheers Leigh will have a go with that later

Steve