Port J ???

[beambase]

I am programming a 18F8490 that has Port J. But in the Flowcode you can only select Port A > Port I. Port I does not exist on the 18F8490.
Any fix for this?

[Benj]

Hello

Here is an updated FCD file. Please can you confirm if it fixes your problem.

[beambase]

no... the problem is nowthat if I use a dialouge box to set a connection to Port J... I can't. The dialouge box stille shows Port A > I and when I i selected, a diolouge shows saying that "Port I does not exist on this device"

[Benj]

Ok I think I have fixed it now.

[beambase]

Looks good in Flowcode but when compiling I get the following errors:



Panel8490b.c(573:2): error: unknown identifier 'trisi'
Panel8490b.c(573:2): error: invalid operand 'trisi'
Panel8490b.c(573:8): error: failed to generate expression
Panel8490b.c(574:13): error: unknown identifier 'porti'
Panel8490b.c(574:13): error: invalid operand 'porti'
Panel8490b.c(574:19): error: failed to generate expression
Panel8490b.c(574:19): error: invalid operand '& '
Panel8490b.c(574:27): error: failed to generate expression
Panel8490b.c(574:27): error: invalid operand '=='
Panel8490b.c(574:9): error: failed to generate expression
Panel8490b.c success

failure

Return code = 1

Flowcode was unable to compile the flowchart's C code due to the following errors:

[Benj]

Hello

Have you changed the registers from porti to portj?

I just created a simple test program to output 0 to port j and the code compiled correctly.

Here is the compiled C code.

Code: Select all

	//Output
	//Output: 0 -> PORT J
	trisj = 0x00;
	portj = 0;