Hello Martin,, the path was wrong, I don't know why. However, I still had to learn something about Fuse bits. Oscillator mode, CLK-Out and Clk divided by 8 can be taken out of the configuration. This is set with fuse bits. Now it works roughly. The sine signal from the PWM is not a smooth wave, but ...

Hello Martin,

many thanks for that. Unfortunately there is an error message when compiling. I have attached the compiler message and test project. Do you have any ideas?

Thank you
Dirk

I have the impression that there is currently only support for ESP32. I have to start a project with the Attiny84. But I can only buy the Attiny84A, for example. I can't get any usable results with this chip. There is no Uart, what about the USI? According to the data sheet, the USI generates an int...

Hello Ben, I have found out. You have to edit the component MCP45XX and change the address from 0x28 to 0x38 during initialisation. The MPC45HVX also only has 256, not 257 steps, but has two hardware addresses. Please bear this in mind. Then the new component should only contain one potentiometer. T...

Hello Martin,

many thanks for that. I will report back as soon as I have tried it out.

best regards

Dirk

Hi Ben, it does not work with the componente MCP45XX. Can I edit this component so that it also works with the MCP45HVX? I need these pots with high voltage support. This is even more important for me than the support of the Digi Pot AD5280 / 5282. I discovered the MCP45HVX later. Thank you very muc...

Hi Ben,

thanks for that.

Dirk

Hello Ben, I would like to use the Digi-Pot MCP45HVX1. Flowcode supports the MCP4551 potentiometer, which is the same but does not support high voltage. The fixed addresses are different. Does the MCP45XX component also work with these potentiometers, or are other addresses sent via I2C? Thank you f...

Hi Ben and all of the team,

can you please add support for the Digi Pot AD5280 / 5282?

Thank you very much

Dirk

Hello,

only a few and only older AVR MPU's are supported. Is it possible to add the AVR DD family?
I especially need support for the AVR64DD14/20.

Many thanks
Dirk