Thanks
Compiles to Hex using an STM fine also.
Regards
Search found 7 matches
- Fri Jun 23, 2023 9:05 am
- Forum: Bug Reports
- Topic: LED_WS82811 compiler error
- Replies: 6
- Views: 950
- Tue Jun 20, 2023 11:34 pm
- Forum: Bug Reports
- Topic: LED_WS82811 compiler error
- Replies: 6
- Views: 950
LED_WS82811 compiler error
hi For some reason, but I'm pretty sure that the problem starts after the last update (Flowcode v10.0.3.31) (I didn't see the problem yesterday) LED_WS82811 component stops the project from compiling. The problem is the same even if no other components are inside the project just an empty project an...
- Mon Jun 27, 2022 10:15 pm
- Forum: General
- Topic: Flowcode Exchange
- Replies: 19
- Views: 22651
Re: Flowcode Exchange
Maybe I'm wrong and I apologize in advance but all the free components on the FlowcodeXchange are out of stock, or I can't find a way to download the component (ADS1115 AD Converter 16-bit I2C Interface).
I apologize once again if I'm wrong
I apologize once again if I'm wrong
- Thu May 05, 2022 11:35 pm
- Forum: Bug Reports
- Topic: STM32F446 wrong internal CAN RX/TX pins
- Replies: 4
- Views: 1602
Re: STM32F446 wrong internal CAN RX/TX pins
Please sorry my mistake PLLM was set wrong, now when I set it to PLLM = /10 everything looks ok
- Thu May 05, 2022 2:53 pm
- Forum: Bug Reports
- Topic: STM32F446 wrong internal CAN RX/TX pins
- Replies: 4
- Views: 1602
Re: STM32F446 wrong internal CAN RX/TX pins
Thanks a lot for the quick response and corrections now CHAN tx works perfectly :D :D , but I can't get anything on RX. NI-CAN (as a sender) sends a message properly, if I put pin B8 as input I detect the signal, but Can1::CheckRx(0) is always 0. logic2 log.jpg Looking at Cubemx there is a possibili...
- Mon May 02, 2022 7:57 pm
- Forum: Bug Reports
- Topic: STM32F446 wrong internal CAN RX/TX pins
- Replies: 4
- Views: 1602
STM32F446 wrong internal CAN RX/TX pins
Dear it seems to me that on the internal CAN component on the STM32F446RET6 chip CAN1_RX and CAN1_TX have been replaced according to the STM32CubeMX cubeMX.jpg in flowcode is flow.jpg PB8 should be CAN1_Rx PB9 should be CAN1_Tx Since Flowcode does not give an option in the drop menu to change, is th...
- Tue Jan 04, 2022 2:16 pm
- Forum: General
- Topic: stm32 chip support
- Replies: 1
- Views: 1115
stm32 chip support
respected
I see that there is f32446RE in the list of supported chips, is it possible to use STM32F446RCT6 instead of F32446RE, according to STM these are very similar chips (same pinout) only the amount of memory is different.
Thank in advance
I see that there is f32446RE in the list of supported chips, is it possible to use STM32F446RCT6 instead of F32446RE, according to STM these are very similar chips (same pinout) only the amount of memory is different.
Thank in advance