Hi So hot up in the Ivory Tower that I ddn't need an iron to melt the solder.... Put together that little noise generator and have to say the quality of the kit is very good. Once complete I connected to a scope. 100_0240.JPG Bear in mind I only paid a few pounds.... Next will be to create some filt...

Hi

My view is it is Interrupt on Change, any change, therefore it is up to you how you handle the response.

Does the datasheet specifically state that you can mask IOC to suit your specific needs? I'm not an expert on that chip but I do remember Int0/1 can be masked.

Hope this helps.

Regards

Hi I'm not an expert on UNO. Int0 and Int1 can be selected to trigger on various "edges" as documented in the interrupt properties. IOC on the remaining ports do set a flag (green) which indicates a trigger on both edges (Interrupt On Change). If you set pins, close and reopen the window you will se...

Hi

when I put my hand near my Arduino it starts reading random inputs

That sounds like the inputs are floating (unconnected, no weak pull-up / down) and when your hand goes near, the capacitive effect is causing the inputs to change.

I'd confirm your connections to start with.

Regards

Hi Following on from the above. This time I used the same setup as documented in the above posts but using software mode with the following results Measured (cm) / Displayed (cm) / Pulse Width (mS) 109 / 78 / 6.27462 120 / 86 / 6.9197 140 / 100 / 8.0691 144 / 103 / 8.32248 162 / 116 / 9.3676 I have ...

Hi

Impressive stuff indeed.

I hope that's a screenshot from your Sinclair

Regards

Hi

Have you looked at the WiKi example?

Regards

Hi

You need to be a bit more specific in your requirement.

Android, Linux and Windows already have serial programs that can do such.

What is it you actually want it to do?

Regards

Hi Lab is in a bit of a state just now, in the process of a good clean out, getting rid of the "might come in handy" pile amongst a LOT of acquired useless junk. That's my "Ivory Tower" up in the clouds, i.e. the mezzanine floor I built to elevate my status :) Scopes / analysers / soldering / test e...

Hi Whenever I could squeeze in the time I've been working my way through the tutorials and decided I needed a "white noise" generator so that I can experiment with filters a bit better. Six weeks later I'm in possession of a Chinese generator. Now I knew it was a kit but must admit to being surprise...