Got myself a few of these from AZ delivery https://www.amazon.co.uk/AZDelivery-XPT ... merReviews
There are 5 pins to deal with data/clock etc in serial mode but the fc module uses a 6th Dataport_low defaulting to C.0 Where does it get connected?
Its the same layout as below http://www.lcdwiki.com/2.4inch_Arduino_Display
Pointers much appreciated
2.4 inch ILI9341 display advice
-
- Posts: 254
- http://meble-kuchenne.info.pl
- Joined: Tue Jul 13, 2021 1:53 pm
- Has thanked: 33 times
- Been thanked: 23 times
2.4 inch ILI9341 display advice
- Attachments
-
- ili9341 az delivery uno v pic test.fcfx
- (10.1 KiB) Downloaded 95 times
-
- Matrix Staff
- Posts: 1739
- Joined: Mon Dec 07, 2020 10:06 am
- Has thanked: 440 times
- Been thanked: 603 times
Re: 2.4 inch ILI9341 display advice
Hello,
The information you linked to states Module Interface 8-bit parallel interface
I don't think you will be able to use these displays in SPI mode.
How about this for the parrallel connections..
If you also want to use the SD card socket then you can link the SD card / FAT component to the four SD_ connections.
I'm not seeing any touch connections which is odd as it says it has touch capability and shows a stylus.
The information you linked to states Module Interface 8-bit parallel interface
I don't think you will be able to use these displays in SPI mode.
How about this for the parrallel connections..
If you also want to use the SD card socket then you can link the SD card / FAT component to the four SD_ connections.
I'm not seeing any touch connections which is odd as it says it has touch capability and shows a stylus.
Regards Ben Rowland - MatrixTSL
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel
Re: 2.4 inch ILI9341 display advice
Thanks Ben. I did think I would need to use a full port for the data. Kind of limits the capabilities of any circuit i put it in but should work pretty fast. I'll give it a go over the next couple of days and get back