Hi everyone
I still have problems compiling code with WiFi and NTP time on esp WiFi kit 32. I can control outputs and write to display ok. All libraries and software upto date.
Thanks
Wayne M
Problems compiling
-
- Posts: 94
- http://meble-kuchenne.info.pl
- Joined: Fri Dec 04, 2020 6:12 pm
- Has thanked: 1 time
- Been thanked: 9 times
-
- Valued Contributor
- Posts: 1149
- Joined: Thu Dec 03, 2020 10:57 am
- Has thanked: 285 times
- Been thanked: 412 times
Re: Problems compiling
Hi
I'm guessing this is a follow on to previous posts?
As a few others can compile OK (at least to Hex) it would appear that perhaps the issue is local to your installation. Can you try and narrow it down a bit?
Could you create a simple chart that does compile then add in each component in turn? That may help point to the issue.
Regards
I'm guessing this is a follow on to previous posts?
As a few others can compile OK (at least to Hex) it would appear that perhaps the issue is local to your installation. Can you try and narrow it down a bit?
Could you create a simple chart that does compile then add in each component in turn? That may help point to the issue.
Regards
-
- Posts: 94
- Joined: Fri Dec 04, 2020 6:12 pm
- Has thanked: 1 time
- Been thanked: 9 times
Re: Problems compiling
I have done this. I can control outputs and write to LCD this is ok.
I have added WiFi Comms as read said and it fails also added NTP time with WiFi and fails to compile.
Wayne m
I have added WiFi Comms as read said and it fails also added NTP time with WiFi and fails to compile.
Wayne m