Hi,
New user, non C programmer, question:
Can Flowcode9 and/or Apps Developer "C" code be swapped (copied ?), or otherwise ported in some manner, between CubeMX <-> Flowcode? Of particular interest is using CubeMX with TouchGFX for a "wrapper" then adding the Flowcode generated code within the "user" section of MX; OR, adding MX/TouchGFX generated code within Flowcode. {combining the very best of both worlds?}
And, if so, where might I find further information and guideance?
Thanks in advance - and thanks for your extremely useful and great program!
Merry Christmas and have a Happy New Year...
dav hal
STM32 CubeMX code porting?
-
davhal
- Posts: 9
- http://meble-kuchenne.info.pl
- Joined: Tue Dec 08, 2020 4:24 pm
- Been thanked: 2 times
-
LeighM
- Valued Contributor
- Posts: 401
- Joined: Mon Dec 07, 2020 1:00 pm
- Has thanked: 73 times
- Been thanked: 218 times
Re: STM32 CubeMX code porting?
Hi,
Most of the STM HAL functionality can be called from C icons within Flowcode, at least in the case of libraries that we include in the standard build.
For any other CubeMX code there is the possibility of including this into a Flowcode project.
Please see this previous forum post ...
https://www.matrixtsl.com/mmforums/view ... 49#p103149
Hope that helps and gets you started
Leigh
Most of the STM HAL functionality can be called from C icons within Flowcode, at least in the case of libraries that we include in the standard build.
For any other CubeMX code there is the possibility of including this into a Flowcode project.
Please see this previous forum post ...
https://www.matrixtsl.com/mmforums/view ... 49#p103149
Hope that helps and gets you started
Leigh