Hi,
The APA102 demo project (and others I have saved from it) do not save the port pins. I set the clock pin to G2 and MOSI to G25 and all works fine. When I re open the project they have reverted back to G10 & G11.
Bob
Project does not save port pins
-
- Posts: 279
- http://meble-kuchenne.info.pl
- Joined: Sat Mar 19, 2022 4:53 pm
- Has thanked: 25 times
- Been thanked: 30 times
-
- Matrix Staff
- Posts: 1491
- Joined: Wed Dec 02, 2020 11:07 pm
- Has thanked: 536 times
- Been thanked: 485 times
Re: Project does not save port pins
Hi Bob.
Hopefully, this will sort your issue out.
Browse to this location using file explorer , it's hidden by default so just paste the link into your address bar.
Place the attached component.
If Flowcode is already open, then you will need to reload your project for the new component to work
If you run any component updates, then the component you added will be overwritten, so it will stop working again.
Hopefully, this will sort your issue out.
Browse to this location using file explorer , it's hidden by default so just paste the link into your address bar.
Code: Select all
C:\ProgramData\MatrixTSL\FlowcodeV10\Components
If Flowcode is already open, then you will need to reload your project for the new component to work
If you run any component updates, then the component you added will be overwritten, so it will stop working again.
- Attachments
-
- LED_APA102C.fcpx
- (13.28 KiB) Downloaded 53 times
Martin