Hi FC9 users. Trying to do a PANEL showing several alphanumeric results simultaneously.
The original "Console Viewer" component seems to do this task with minimal of three columns and three lines.
But after RUN it, even trying with the 5 available component´s macros I got three columns, but just ONE LINE .
How could I JUMP to the NEXT LINE ? Witch macro or extra command do I use to do this ?
Thanks for any tip !
Console Viewer - how to JUMP LINES ?
-
- Posts: 29
- http://meble-kuchenne.info.pl
- Joined: Sat Nov 21, 2020 10:38 pm
- Has thanked: 18 times
- Been thanked: 2 times
Console Viewer - how to JUMP LINES ?
- Attachments
-
- Console Viewer original.jpg (52.13 KiB) Viewed 924 times
-
- Console Viewer after RUN.jpg (34.31 KiB) Viewed 924 times
-
- Matrix Staff
- Posts: 1767
- Joined: Mon Dec 07, 2020 10:06 am
- Has thanked: 449 times
- Been thanked: 610 times
Re: Console Viewer - how to JUMP LINES ?
Hello,
I would guess that Append text with the following should give you a new line.
AppendText ( "\r\n" )
I would guess that Append text with the following should give you a new line.
AppendText ( "\r\n" )
Regards Ben Rowland - MatrixTSL
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel
-
- Posts: 29
- Joined: Sat Nov 21, 2020 10:38 pm
- Has thanked: 18 times
- Been thanked: 2 times
-
- Posts: 29
- Joined: Sat Nov 21, 2020 10:38 pm
- Has thanked: 18 times
- Been thanked: 2 times
Re: Console Viewer - how to JUMP LINES ?
Hi. Still trying to create a 2 lines X 3 colunms matrix to display 6 dynamic values and theirs units (6 measurements, for example).
All 6 values are recalculated in time.
But even including the "\r\n" commands inside "AppendText" macro at various experimental points (the toggled off one´s)
I never got 2 lines, just 1 line all the times.
I can´t show the 6 measurements instantly formated like a panel.
I´ve included the code. Thanks.
All 6 values are recalculated in time.
But even including the "\r\n" commands inside "AppendText" macro at various experimental points (the toggled off one´s)
I never got 2 lines, just 1 line all the times.
I can´t show the 6 measurements instantly formated like a panel.
I´ve included the code. Thanks.
- Attachments
-
- Just one line.PNG (95.96 KiB) Viewed 853 times
-
- Just One Line.fcfx
- (21.41 KiB) Downloaded 42 times