This has now been fixed, so you will need to do a Full database component update, then reload your project.
To do a full component update, when you run a library update via Help > Library updates..., you must change the Files in-use to Full database.
UART, I2C, SPI that don't retain pins in software mode
-
- Matrix Staff
- Posts: 1464
- http://meble-kuchenne.info.pl
- Joined: Wed Dec 02, 2020 11:07 pm
- Has thanked: 514 times
- Been thanked: 474 times
-
- Valued Contributor
- Posts: 760
- Joined: Wed Dec 02, 2020 10:53 am
- Has thanked: 150 times
- Been thanked: 171 times
Re: UART, I2C, SPI that don't retain pins in software mode
Hi Martin
Very good. Thank you very much.
Can you please also improve the hardware channel.
So that this is also saved.
For example the component:
LSM9DS1_AccelGyroMagnet1
regards
Stefan
Very good. Thank you very much.
Can you please also improve the hardware channel.
So that this is also saved.
For example the component:
LSM9DS1_AccelGyroMagnet1
regards
Stefan
-
- Matrix Staff
- Posts: 1464
- Joined: Wed Dec 02, 2020 11:07 pm
- Has thanked: 514 times
- Been thanked: 474 times
Re: UART, I2C, SPI that don't retain pins in software mode
Hi Bob.
The components fixed are available within the Full database updates.
If the component you are using has not been updated, then we need to look into what the issue is.
Thank you for bringing it to our attention
The components fixed are available within the Full database updates.
If the component you are using has not been updated, then we need to look into what the issue is.
Thank you for bringing it to our attention
Martin