Hello, please tell me how I can change the vref option parameter in accordance with what I need? In older versions of the flowcode there was a choice of Vref option = VDD, but neither fc9 nor fc10 has this anymore. Maybe it's possible somehow? Very necessary.
The screenshot shows that the choice is fixed, but it is not suitable for processors with a 3.3 volt power supply.
Help please.
Question about Vref option FC9.
-
vvvhydr
- Posts: 15
- http://meble-kuchenne.info.pl
- Joined: Wed Dec 01, 2021 7:22 am
- Has thanked: 1 time
Question about Vref option FC9.
- Attachments
-
- Flowcode1.fcfx
- (8.06 KiB) Downloaded 7 times
-
- ADC.PNG (199.69 KiB) Viewed 2110 times
-
medelec35
- Matrix Staff
- Posts: 1805
- Joined: Wed Dec 02, 2020 11:07 pm
- Has thanked: 602 times
- Been thanked: 598 times
Re: Question about Vref option FC9.
Hello.
You can only select what the target devices allow.
This is from the expressive site:
Notice the information states There are 4 available attenuation options.
As you can see the figures on the right match the internal reference voltages on the ADC component withing Flowcode.
You can only select what the target devices allow.
This is from the expressive site:
- adc internal refference.png (63.84 KiB) Viewed 2014 times
As you can see the figures on the right match the internal reference voltages on the ADC component withing Flowcode.
Martin