Hello Matrix,
I belive I found a Bug in the PWM component with PIC18F2520.
If you assign PWM Channel-2 to the alternate port (Port B3), the hardware is not giving you the PWM signal
Channel-2 Port C1 is OK
Channel-1 Port C2 is OK
Attached the FC file:
Foto too:
It would be great if some one could fix this issue.
Thanks in advance
Dirk
PWM component alternate port problem with PIC18F2520
-
- Posts: 92
- http://meble-kuchenne.info.pl
- Joined: Fri Dec 04, 2020 11:03 am
- Has thanked: 6 times
- Been thanked: 12 times
-
- Matrix Staff
- Posts: 1786
- Joined: Mon Dec 07, 2020 10:06 am
- Has thanked: 455 times
- Been thanked: 621 times
Re: PWM component alternate port problem with PIC18F2520
Hi Dirk,
If you go into the Build -> Project Options then look at the Configure section there is a setting marked CCP2 Mux, You need to change this from RC1 to RB3.
Hopefully this will get things working for you.
If you go into the Build -> Project Options then look at the Configure section there is a setting marked CCP2 Mux, You need to change this from RC1 to RB3.
Hopefully this will get things working for you.
Regards Ben Rowland - MatrixTSL
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel
Flowcode Online Code Viewer (Beta) - Flowcode Product Page - Flowcode Help Wiki - My YouTube Channel