ESP tool chain not installed!

[jgu1]

Hi!

Just received my ESP 32 and want to test. After install the toolchain I try to compile to chip, I get the message "ESP toolchain not installed is there some special I have to do?

Br jorgen

[LeighM]

Did you follow all the instructions in the link below, carefully
... including the Flowcode Global setting?
https://flowcode.co.uk/wiki/index.php?t ... Toolchains

[jgu1]

Tryed again, and yes, I have forgot the location in global setting, sorry. Now it begin to compile, but will not program the ESP32

[LeighM]

You also need to set the COM programming port, see this post ..
viewtopic.php?p=57#p57

Some ESP modules also need the BOOT switch pressed when programming.

[jgu1]

Hi LEigh!

Your suggest already tryed. I cannot see any comport in the settings , no matter what I do. I hear the pling when I connect the USB and see Com17 when I att the USB in devicemanager

[jgu1]

Hi Leigh!

What can I do please

Br

Jorgen

[LeighM]

Have you selected COM17 as the programmer port on the Project Options screen?

This works similar to the port for Arduino programming.

[jgu1]

Hello Leigh!

Ok, well, could not find it in the manual

Now I can compile. Thank you.

Br Jorgen